High Pressure Coolant Systems

High-pressure coolant is an exceptional tool for performing deep hole operations such as gun-drilling and boring. Properly applied, high-pressure coolant is an effective solution for all chip control problems.

Direct high-pressure coolant can either break or control the chip away from the tool and workpiece thereby increasing tool life and improving finishes.

Cycle time for drilling can be reduced 40 - 70% with direct high- pressure coolant. The material is less likely to work harder, making drilling easier and in many cases eliminating the need for peck drilling cycles!

  • High-speed Drilling Operations
  • Chip Control For Turning And Grooving Improved Surface Finish
  • Increased Tool Life
  • Reduced Cycle Time
  • Greater Throughput

5 Line System
Model CB105V


Features:

  • Coolant is continuously filtered through 5 micron filter
  • Independent feed pump improves filter bag life
  • 5 high pressure coolant lines
  • Washable air inlet filter
  • Space saving vertical design

5 & 10 Line Systems with Heat Exchanger
Model CB510 Available in Horizontal & Vertical Designs


Coolant moves through 5 micron filter and heat exchanger providing filtration and heat removal even when the high pressure system is not in operation reducing operating temperature of the coolant.

Specifications:

  • 2,000 PSI, 6.5 GPM
  • 7.5 HP
  • 5 micron filtration
  • Heat exchange system
  • PLC control integration
  • Electrical interface harness
  • Installation kit (HP hoses, fittings, manifold blocks for coolant distribution)
  • Diagnostic indicator lights
  • Restricted filter automatic shut off
  • Voltage: 200/230V 40.0 full load amps (optional 440/480V 30.0 full load amps)

Features:

  • Independent feed pump standard
  • 2,000 CFM heat exchange system standard
  • Vertical or horizontal design
  • Available in 5 and 10 line systems

Dual Filter High Pressure Coolant System
Model CB610V 10 line system with Heat Exchanger


The CB610 dual filter system is designed to automatically change-over to the secondary filter when the primary filter becomes clogged. The filter change-over will not stop production, therefore unattended or third shift operations can continue without disruption.

Features:

  • No loss of production to change clogged filter
  • Automatic change over from clogged filter to clean filter
  • System removes excess heat from coolant during operation
  • Independent feed pump improves filter bag life
  • Air purge system automatically removes coolant from clogged filter canister
  • Washable air inlet filter provides clean air flow for heat exhange system
  • Space saving vertical design: 19.5” x 51.4” x 43.4”

Specifications:

  • 2,000 PSI, 6.5 GPM
  • 7.5 HP
  • 5 micron filtration
  • Heat exchange system
  • PLC control integration
  • Electrical interface harness
  • 10 high pressure coolant lines
  • Installation kit (HP hoses, fittings, manifold blocks for coolant distribution)
  • Diagnostic indicator lights
  • Voltage: 200/230V 40.0 full load amps (optional 440/480V 30.0 full load amps)

Contacts

Email: sales@citizenswiss.com
Phone: +1 574 472 7850